Maintenance and Cleaning Supplies
Keep your Flavor Burst running smoothly, safely and in compliance with NSF standards. Two different sanitizer solutions are needed for your system — one for immediate and daily cleanings and one for storing in the tank for the Spout Flush function. Each has different properties that are approved for their specific purposes. We also recommend a variety of brushes, from large to tiny, to ensure proper cleaning standards. Refer to your operations manual for full instructions and procedures.
For your convenience, Flavor Burst Company is pleased to recommend the following products for use with our systems. Please see the table below.
Also, check out our Cleaning & Maintenance Tutorials for step-by-step video instruction on how to keep your Flavor Burst system NSF compliant and in good working order. CLICK HERE to see our available videos.
| Sanitizer Solutions | Where to Buy | Type | Mixing Levels | Purpose / Notes |
|---|---|---|---|---|
| Stera-Sheen Green Label by Purdy Products |
Your local Taylor Distributor may carry this product. |
Powder | Mix 2 oz of Stera-Sheen Green Label with 2 gallons of warm water. | For daily sanitation of Flavor Burst parts. Use within 1 hour of preparing solution. Will lose effectiveness within 24 hours. Can be used in the sanitizer tank to clean syrup lines and pumps only when performing the monthly Clean-In-Place Procedure and winterizing the system. Do not store in the tank for more than 24 hours. Always use a fresh supply. Do not use in the sanitizer tank for Flush Spout function in between monthly Clean-In-Place Procedures (use Envirokleen No-Rinse instead). |
| No-Rinse Cleaner by Envirokleen ECS |
Your local Taylor Distributor may carry this product. |
Liquid | Mix 1 oz of No-Rinse Cleaner with 2 gallons of warm water. | For use in Flavor Burst sanitizer tank for the Spout Flush function. Maintains potency for up to 30 days. Refill tank with a fresh supply at least every 30 days. For Clean-In-Place Procedure, winterizing the unit, and daily cleaning of parts, use Stera-Sheen Green Label sanitizer as instructed above. |
| Cleaning Tools | Where to Buy | Part No. | Purpose / Notes |
|---|---|---|---|
| Taylor 3pc Detail Brush Set |
Your local Taylor Distributor may carry this product. |
050103 | For cleaning very small or hard-to-reach areas such as the Injector Head syrup port and syrup tubes, Gear Cartridge Teeth, and Syrup Line Manifold. |
| Taylor 1/2″ diameter Brush |
Your local Taylor Distributor may carry this product. |
033059 | For cleaning smaller areas of parts such as o-ring grooves, Gear Box openings, and syrup line connectors. |
| Taylor Brush 1″ x 2″ |
Your local Taylor Distributor may carry this product. |
013073 | For cleaning the exterior and openings in parts such as the Spout Adapter, Gear Cartridge, Gear Box, Syrup Line Manifold, and Injector Head. |
| Taylor Draw Valve Brush 1.5″ x 3″ |
Your local Taylor Distributor may carry this product. |
014753 | For cleaning the exterior and openings in parts such as the Spout Adapter, Gear Cartridge, Gear Box, Syrup Line Manifold, and Injector Head. |
| O-Ring and Adapter Removal Tool |
Your local Taylor Distributor may carry this product. |
048260-WHT | For removing the o-rings and gaskets of parts such as the Spout Adapter and Injector Head. Also can be used to pry off the Spout Adapter from the freezer door. |
| Taylor Sanitary Lube (Food-Grade) |
Your local Taylor Distributor may carry this product. |
047518 | For lubricating the o-rings of parts such as the Spout Adapter and Injector Head when instructed by the Operations Manual. |